The NanOsc Instruments line of broadband ferromagnetic resonance (FMR) spectrometers offer a simple turn-key solution to the burgeoning field of magnetodynamics research. Broadband FMR spectroscopy allows for measurements continuously spanning several 10’s of GHz. Measurements over a wide frequency range allow for significant improvements in accurately extracting a variety of material parameters not accessible by static measurement techniques. Broadband FMR is particularly well-suited for studying magnetic thin films, which not only form the backbone of fundamental spintronics and magnonics research but are also constituents of current and future technologies focused on magnetic memories, sensors, logic, and microwave signal processing.
NanOsc FMR Spectrometers
The NanOsc Instruments line of broadband ferromagnetic resonance (FMR) spectrometers offer a simple turn-key solution to the burgeoning field of magnetodynamics research.
Features
- Turn-key FMR spectrometer with easy to use software interface
- Broadband FMR using a coplanar waveguide
- Measures effective magnetization (Meff), anisotropy (K), gyromagnetic ratio (γ), damping (α), inhomogeneous broadening (ΔHO), exchange stiffness (A), inverse spin Hall effect (ISHE) voltage
Specifications
Instrument | Bandwidth* | Temperature Range | Magnetic Field |
PhaseFMR-8 | 2-8 GHz | Room Temperature | User Supplied Electromagnet / Power Supply |
PhaseFMR | 2-18 GHz | ||
PhaseFMR-40 | 2-40 GHz | ||
CryoFMR-8 | 2-8 GHz | 4-400 K: PPMS / DynaCool
55-400 K: VersaLab 10-350 K: MI Cryostation |
±9, 14, 16 T: PPMS / DynaCool
±3 T: VersaLab ±0.7 T: MI Cryostation |
CryoFMR | 2-18 GHz | ||
CryoFMR-40 | 2-40 GHz |
Related products
Quantum Design
Rainbow Photonics was founded as a spin-off company from the Nonlinear Optics Laboratory of the Swiss Federal Institute of Technology, ETH Zurich, in 1997. The company offers a series of novel terahertz instruments for imaging and spectroscopy.
Quantum Design
This is considered the standard type of self-sensing cantilever. It exhibits a sharp tip made of silicon with a tip radius of <15 nm. Normally, the cantilever is delivered on our cantilever PCB (CL-PCB) with a small 10 pin connector on its lower side. On request you can order only the Si chip without PCB […]
Quantum Design
AFSEM™ is an atomic force microscope (AFM) by GETec Microscopy, designed for integration in a SEM or Dualbeam (SEM/FIB) microscope.
Quantum Design
Quantum Design's Advanced Technology Liquefiers (ATL) along with its innovative Helium Recovery, Storage & Purification Systems allow you to recover and liquefy the helium gas currently being lost from the normal boil off and helium transfers of your cryogenic instruments.
Quantum Design
These are self-sensing cantilevers with a hard, sharp, long-life single crystal diamond tip (SCD). The cantilever is delivered on our cantilever PCB (CL-PCB) with a small 10 pin connector on its bottom side. This cantilever type can come with or without an integrated heater. PRSA (Piezo-Resistive Sensing & Active) cantilever probes are equipped with an […]
Quantum Design
Quantum Design brings its 30+ years of low temperature instrumentation design to the development and manufacture of an innovative line of compressors and Gifford-McMahon (G-M) closed-cycle cryo-refrigerators. Variable speed energy efficiency, longer uninterrupted run times between servicing, and low vibration operation are all hallmarks of these cryogenic refrigeration products.
Quantum Design
Single Quantum’s Eos X10 CS is a superconducting nanowire single photon detector (SNSPD) closed-cycle system with unparalleled detection efficiency in the near infrared spectrum.
Quantum Design
Manufactured by GES Corporation, this tetra arc crystal furnace uses the Czochralski pulling method and four electric arcs to grow a wide range of metallic-conductive materials such as metallic compounds and high-temperature superconductors.